top of page

The Masterpiece Series has in fact been on our internal road map for some years, but was not supposed to be introduced until 2011. However as the number of requests from the market increased, we decided to bring development forward and launch this very special series early. We think it is somewhat fitting for a range of products that are ahead of their time!


The complexity of all the MP products has put our engineering team to the test, as the technology used in the Signature Series needed to be pushed to the extreme, to satisfy our expectations for the new Masterpiece Series.


To reach this level, we had to re-qualify all parts from component level and up. Furthermore, many new custom made parts were developed, pushing our subcontractors technologies to the limit of “possible”. All true balanced discrete gainstages in the MP-L201 are based on shielded modules, which incorporates a very high level of integration. Each module is moulded with special damping material, which takes care of both mechanical resonances and stability in temperature. This gives optimal working conditions for the circuitry.


Mk.II Introduction With the introduction of the mk.II version 1Q17, yet another level has been reached. Especially the powersupply has undergone a massive redesign, not only increasing the total number of regulation steps, but also increasing the performance of each regulator steps. This results in further silence and wider and deeper soundstage - to name a few. Modules has been improved in bandwidth and precission which gives further improvement on resolution and micro details.

Vitus Masterpiece MP-L201 mk ii Preamplifier

  • Technical Specifications

    INPUT                          XLR analog                     RCA analog

                                          3 (L+R)                            2 (L+R)

    Sensitivity select           2/4/8 VRMS                   2/4/8 VRMS 

    Impedance                   10KΩ                             10KΩ

    Slew rate                      1000V/ μs                      1000V/ μs


    OUTPUT                      XLR analog                    RCA analog      RCA BP

                                           2                                    2                       1

    Impedance                   75 Ω                              75 Ω

    Frequency response     +800KHz                      +800KHz

    Signal to noise ratio      >110dB                          >110dB

    THD + noise                  > 0,01%                         > 0,01%


    VOLUME CONTROL    Type Relay controlled fixed resistor network

    Gain                              -91,5dB to +18dB



    Standby                        0,7W (CPU on)

    Idle Mode                     30W   (PSU still on)

    Operation                     88W (Fully operational)


    DIMENSIONS               PSU                               AMP

    Height                          135 mm                         135 mm

    Width                           435 mm                         435 mm

    Depth                           430 mm                         430 mm

    Weight                          35 Kg                            21 Kg



bottom of page